Differences between revisions 21 and 23 (spanning 2 versions)
Revision 21 as of 2005-11-11 07:00:25
Size: 2273
Editor: PeMac
Comment:
Revision 23 as of 2005-11-11 07:01:25
Size: 2282
Editor: PeMac
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
This page is about boot Linux USB pendrives in any computer. This page is about boot Linux via USB pendrives in any computer.
Line 11: Line 11:
You need a USB device with standard mass storage interface and with, '''at least, 128 MBytes''' (the distros uses generally 50 MB) to work with Linux. You need a USB device with standard mass storage interface and with, '''at least, 128 MBytes''' (the distros uses generally 50 -64 MB) to work with Linux.

This page is about boot Linux via USB pendrives in any computer.

BIOS and USB standard mass storage interface

There are two common BIOS methods for direct USB booting:

  • One method is called the "USBHDD" method and it is used to support the booting of standard USB mass storage devices that are configured like a normal PC hard drive.
  • The other method is called the "USBZIP" method and it supports booting from a USB storage device that behaves like the original IOMEGA ZIP drive with USB support.

Most computers (just about all Dells, for example) made today have a BIOS that supports the USBHDD method so I expect that this will eventually become the standard way to boot a USB device. However, many motherboards will support BOTH methods, and many older motherboards have USBZIP support.

You need a USB device with standard mass storage interface and with, at least, 128 MBytes (the distros uses generally 50 -64 MB) to work with Linux.

See StandardPendrive.

USB pendrive location

Most USB pendrives are located at device name "?sda" after they are plugged into the USB port.

However, you can verify this location by typing this command inside a terminal window:

  • dmesg | grep scsi -A 3

and it should tell you the device name for your USB (SCSI emulated) devices and vendor name.

See : ["dmesg"].

Obtain the installation files from ISO file

You have to use IsoBuster (see ["

More information

See also:

  • ?BootingFromFloppyToUsb .

  • ["growisofs"].