Translation(s): none


This describe SDD optimization with system having encrypted root and swap.

/!\ An important aspect in optimizing SSD performance is the file system and partition alignment (1 MiB borders aligned to the 4096 byte blocks of the hardware). This wiki page does not cover these issues.

Reducing writes to solid state disks (SSDs) or laptop hard disk drives (HDDs)

Optimizations for solid state disks (SSDs)

Performance and disk wear of the solid state drive (SSD) can be optimized as follows.

Note that using discard with on-disk-cryptogrpahy (like dm-crypt) has drawbacks with respect to security/cryptography! See crypttab(5).

dm-crypt: /etc/crypttab

#<target name>    <source device>            <key file>  <options>
var  UUID=01234567-89ab-cdef-0123-456789abcdef  none  luks,discard

More: http://siduction.org/index.php?module=news&func=display&sid=78 http://forums.debian.net/viewtopic.php?f=16&t=76921 https://wiki.archlinux.org/index.php/SSD http://wiki.ubuntuusers.de/SSD

/etc/fstab

# /etc/fstab: static file system information.
#
# Use 'vol_id --uuid' to print the universally unique identifier for a
# device; this may be used with UUID= as a more robust way to name devices
# that works even if disks are added and removed. See fstab(5).
#
# <file system> <mount point>   <type>  <options>       <dump>  <pass>
### SSD: discard,noatime
### match battery operation default for commit JOURNAL_COMMIT_TIME_AC in Add files in /etc/pm/config.d/*
/dev/mapper/goofy-root /               ext4    discard,noatime,commit=600,errors=remount-ro 0       1
# /boot was on /dev/sda1 during installation
UUID=709cbe4a-80c1-46cb-8bb1-dbce3059d1f7 /boot           ext4    discard,noatime,commit=600,defaults        0       2
### SSD: discard
/dev/mapper/goofy-swap none            swap    sw,discard              0       0
/dev/mapper/goofy-chroot /srv/chroot         btrfs    ssd,discard,noatime 0       2
/dev/scd0       /media/cdrom0   udf,iso9660 user,noauto     0       0

/etc/lvm/lvm.conf

...
# This section allows you to configure which block devices should
# be used by the LVM system.
devices {
...
    # Issue discards to a logical volumes's underlying physical volume(s) when
    # the logical volume is no longer using the physical volumes' space (e.g.
    # lvremove, lvreduce, etc).  Discards inform the storage that a region is
    # no longer in use.  Storage that supports discards advertise the protocol
    # specific way discards should be issued by the kernel (TRIM, UNMAP, or
    # WRITE SAME with UNMAP bit set).  Not all storage will support or benefit
    # from discards but SSDs and thinly provisioned LUNs generally do.  If set
    # to 1, discards will only be issued if both the storage and kernel provide
    # support.
    # 1 enables; 0 disables.
    #issue_discards = 0
    issue_discards = 1
}
...

Smaller system with SSD

See