Differences between revisions 42 and 44 (spanning 2 versions)
Revision 42 as of 2007-04-07 13:37:19
Size: 10307
Comment:
Revision 44 as of 2007-04-27 16:26:00
Size: 10264
Comment:
Deletions are marked like this. Additions are marked like this.
Line 84: Line 84:
 See man semget(2), semop(2) SEM_UNDO. They have been considered and rejected
mainly because of too many potential device names which would need
pre-allocated semaphore objects.
 See man semget(2), semop(2) SEM_UNDO. They have been considered and rejected mainly because of too many potential device names which would need pre-allocated semaphore objects.
Line 118: Line 116:
First: race conditions Unclear or unreliable cleanup technique, dangling bad lockfiles possible
Line 120: Line 118:
Second: unclear or unreliable cleanup technique, dangling bad lockfiles possible

Third:
The most obvious problem is the usual permission setting of /var/lock :
The most obvious problem is the usual permission setting of /var/lock :

On Locking Schemes on Linux Device Drivers

Hello fellow application developer or maintainer,

recently we (cdrkit and libburnia developers) came accross increasing problems with reliable and safe device locking. This paper collects our ponderings after having received this advise from Alan Cox on LKML: http://lkml.org/lkml/2007/3/31/175

Introduction

Our concern is the influence of even read-only operations on optical media drives (recorders) during their duty as recorders -- depending on the device model such read-only work may interrupt the process badly, spoiling the result, eventually wasting the medium.

Since many programs already act on such devices we see the need for reliable communication in order to allow proper device locking if good will for cooperation is present. After such a locking mechanism is implemented, we will invite any project to join it.

In the following document, at first a few possible mechanisms are evaluated. Then a suitable locking algorithm is proposed which needs coordination with the Linux community, nevertheless.

The remaining open questions is:

  • Where to create lock files under a protocol that is not (yet) covered by FHS ?

We do not want to make this choice a reason for the rejection of our proposal.

State of the practice

There are various locking techniques used in other areas which are more or less applicable in our case.

Path/Inode based locking mechanisms

In general, these mechanisms are not optimally appropriate for our purpose. They use the filename or inode as identity. In our case this imposes problems: but they lack on two places which make then not reliable when used alone:

  • they do not cope with multiple device files which imply the access to the same driver through different files
  • they do not automatically cope with multiple device drivers accessible through different co-existing user space interfaces, like with sg vs. sr drivers.

We evaluated:

  • Lock files associated with target file

    Principle: an additional file is created during the action on the real target file. See http://www.pathname.com/fhs/pub/fhs-2.3.html#VARLOCKLOCKFILES Pros: regular filesystem operation, no additional infrastructure required Cons:

    • Possible races unless OS mechanisms are used for exclusive operation on the lock file, see below
    • The location and name of the lock file need to be known and discussed upfront among all application developers, or be documented excessively
    • Permission problems may disallow the creation of lock files (security issues), especially for self-compiled applications and having no root permissions to install them in a required way
    • Special precautions are necessary against stale locks
  • fcntl(2) exclusive file locking Principle: lock applied on open file handles. Thus probably refering to an inode. See fcntl(2) for details. Pros:
    • known (POSIX.1-2001), usually reliable mechanism
    Cons:
    • needs open(2) as precondition which has to be avoided on unlocked device files

Other locking mechanisms

  • O_EXCL locking Principle: passing of the O_EXCL flag to the open call of a device file. The device is locked exclusively for the calling PID, the lock is maintained in the device driver to the particular major/minor combination. Pros:
    • reliable for a device accessible through one driver
    Cons:
    • for sr it requires kernel 2.6.x (x>=7 or so), with sg it might work on 2.4.

    • it does not solve the problem with the co-existing drivers for sr and sg
  • System V Semaphores See man semget(2), semop(2) SEM_UNDO. They have been considered and rejected mainly because of too many potential device names which would need pre-allocated semaphore objects.

Applicability on CD/(HD)DVD/BD drives

As explained in the introduction, the locking is important on optical media recording due to the delicate operation mode during the recording. Ideally, no other application should touch them. Even reading info from the drive can spoil the recording run. Currently we are aware of at least the following participants in drive collisions. They take differing precautions for this case, of which none is really able to prevent inadverted open(2) of a busy drive under all circumstances.

  • mount: the block device is mounted with the O_EXCL flag but the mount executable also uses libblkid which opens the devices without locking and reads magic data from it. (We understand that for the duration of a recording run, mounting should best be prevented in total.)
  • hald (HAL daemon): frequently opens the block devices with O_EXCL flag.
  • wodim: opens the devices with O_EXCL flag. Opening /dev/sg is possible and happens more likely with versions prior to 1.1.4.
  • growisofs: opens the block devices with O_EXCL flag. Opening /dev/sg was never encouraged and does not work on kernel 2.4 (not tested yet on 2.6).
  • cdrskin (via libburn): opens the devices with O_EXCL flag. It uses a unique device file path for serious operations on the drive. This is /dev/sg* on kernel 2.4, and recently has become /dev/sr* on kernel 2.6. The only other permissible paths are /dev/hd* . Operations on other path representations of the same device are restricted to open(2) O_RDONLY and to obtaining SCSI parameters host,channel,id,lun. Mapping to the unique device names is strictly enforced.
  • cdrecord: no locking. Author recommends to do it like Solaris does (which seems to do explicite locking, maintained internally on device driver or on major/minor pairs).

Any of the listed programs is currently able to spoil a recording run just by its proper operation if only the circumstances are unfortunate enough. This compilation is mostly heuristic and may be erroneous in details. Whatever, the problems and the users' disappointment are real.

Obstacles for using FHS compliant /var/lock/ files

Unclear or unreliable cleanup technique, dangling bad lockfiles possible

The most obvious problem is the usual permission setting of /var/lock :

SuSE 9.0 (kernel 2.4):
  drwxrwxr-x    3 root     uucp         4096 Apr  4     05:07 /var/lock
SuSE 9.3 (kernel 2.6):
  drwxrwxr-t    4 root     uucp         4096 2007-04-04 17:50 /var/lock
Fedora Core 3.x:
  drwxrwxr-x    5 root     lock         4096 Apr  4     04:03 /var/lock
Debian gives rw-permission to anybody and thus would be no problem.

Proposed locking algorithm

It adopts the FHS idea of locking a proxy before any open(2) is performed, but avoids the known drawbacks of the FHS /var/lock/ protocol.

It is designed to allow the use of any of the sg, sr, scd device drivers at the discretion of the programs. It is also designed to include the less ambiguous situation of drive access via /dev/hd*.


Compliant processes apply open(2) to suspected CD/DVD burner device files only if they are able to do this via one of the following paths:

  • /dev/sg[0..N] , /dev/scd[0..N] , /dev/sr[0..N] , /dev/hd[a-z]

and only after they have obtained a lock on them. (N= 31 or 255 ?)

Locking is performed similar to UUCP tradition but without the potential race conditions or potential stale locks: Other than with FHS /var/lock, not the mere existence of the lock file establishes the lock state. It is instead implemented by open(2) with O_RDWR and then fcntl(2) with F_SETLK. The lock file descriptor is held open until the lock is obsolete.

Paths other than the permissible ones have to be translated. The call stat(2) with its result element .st_rdev allows to search a matching device file among the permissible ones. So /dev/nec_burner can be translated to exactly one of /dev/sr0, /dev/sg2, /dev/hdd. (If not, then it is hardly a burner device.)

To circumvent the sg-sr-scd ambiguity, those devices must get locked in all their three permissible path instances. E.g. not only /dev/sr0 has to be locked before open(2) for serious usage is allowed, but also /dev/sg2 and /dev/scd0.

The device triples are formed from those device files which have the same SCSI parameters Host,Channel,Id,Lun from ioctl(SCSI_IOCTL_GET_IDLUN). Since this needs open(2), the search has to be accompanied by the locking of the tested files. Those which do not match get released immediately. If all three files are found and locked, it is guaranteed that any of them is free for usage. If any of the three is not found, then the lock is not granted due to a suspected collision between two locking contestants.

This cannot disturb a serious drive operation because such is allowed to start only if all three paths are locked. Thus there would be no starting point for a device-triple search at all.

Further precautions like open(O_EXCL) or fcntl(F_SETLK) on the device file itself are allowed. Programs are asked politely to offer expert options to disable them. In general a program is free to use a device in any way after a lock has been obtained successfully.


All we need for this is a directory which is present on any Linux system and is supposed to offer rwx-permissions to anybody who is allowed to access the devices.

As an application programmer i would propose /tmp/ and some file name prefix. It would work, after all. It would be covered by FHS specs except the fact that /var/lock is the paragraph which matches our problem more specifically - and fails to solve it.

To perform the sketched algorithm in /var/lock would violate FHS. The often restrictive permission settings of /var/lock would also make necessary an additional rule: A missing lock file which cannot be created allows to use the device as if a lock had been granted. (Provident sysadmins would then once create the lock files in /var/lock/ and allow rw-permission for all intended users.)

This is where we should ask the broad Linux public for opinions and advise. We are not much in a hurry and therefore should ponder duely over any aspect.